Jim Post in the USA sent me a USB drive crammed full of building and launch pics of the OZ Goose design – the Big Brother to the OZ Racer (formerly the OZ PDRacer).

Looking forward to some sailing reports!

Jim Post has built the hull of his PD Goose – a 12ft version of the OZ PDRacer.

He has done a nice job with a couple of nice additions. A seat in the middle and a stylishly angular splashboard on the foredeck. I am dying to hear how it sails!

OZ Racer plan information The PDRacers have a saga published at Duckworks about the Texas 200 (the 200 mile sailing event up the Texas Coast). It is not by a Ducker but by one impressed by them. Extract The Mighty Ducks clung to the port, with all manner and various sort of other craft abeam [...]

The PDRacer international forum started discussing a longer version of the humble PDRacer – and I had some drawings on hand already for a 12ft version because of Bob Alston. He actually thought up the name, which I quite like. We really do recommend the OZ PDRacer for most people and you do need to [...]

It is a bit hard finding information on my forum as the list is not very ordered, so I have attempted to fix this.There is a general building section then each boat is in alphabetical order.To see all the images you may need to become a member, however, they are a good bunch and will [...]

One of the new launchings of the Goat Island Skiff had a problem with a slippery floor… Here is my favourite suggestion. Nice way to deal with it is the same way we did the PDRacers. I couldnt find he pics on the building thread. You varnish the cockpit floor normally. Then mask off the [...]

The OZ hollow mast is the bee’s knees – the nicest mast we can come up with at this stage. A simple long box with the faces made of 4 planks 12mm (1/2″) thick with a taper. Easy enough to build about 35% to 40% lighter than a solid mast. Making the mast out of [...]

I like boat trailers that have other functions too. One way is to adapt another type of trailer – like a conventional box trailer at least for smaller boats. An alternative is to go for something very “bare bones”. One thing that makes a boat trailer more useful for different boats is to have a [...]

The first part was up last week. This week we talk about traditional vs modern sailtypes – everyone knows I am a fan of trad rigs because of their low cost – but here I go into the influences on the other side. I love the efficiency of modern rigs so I use all the [...]

The two methods here save a lot of mess when building boats with epoxy. They also allow accurate and fast placement of mixed epoxy glue. Most supermarkets have varieties of “snap lock” bags. They have a seal across the opening of the bag that can be pressed together with finger pressure. They make it a [...]

This is the normal method for fibreglassing small areas – typically using fibreglass tape to hull seams. Here I document the process of coating the hull and glasstaping the chines in one hit. Integration of different steps in this way is one of the major efficiencies of modern epoxy boatbuilding. However if simply glass taping [...]

I have just finished additional drawings for a lug rig version of the OZ PDRacer. Properly designed and engineered spars and sail. I would like to think I am something of an expert on lug rigs ritted to small boats. I have sailed countless hours with such rigs including weekly club races against conventional boats [...]